Parameters for presence detectors

This parameter determines the function that is to be triggered when motion is detected.

This parameter is used to trigger a switching command at the start of a detection.

This parameter defines the type of switching command at the start of a detection.

This parameter is visible only if the function "Switching" is set.

This parameter defines the brightness value that is sent at the start of a detection.

This parameter is only visible when the "Brightness value transmitter" function is set.

This parameter is used to define the scene number that is sent at the start of a recording.

This parameter is visible only if the function "Scene extension" is set.

This parameter specifies the time between the last motion detection and the end of detection.

This parameter is used to set whether a switching command is still triggered at the end of detection. Depending on the set function, further parameters become visible.

This parameter defines the type of switching command at the end of a detection.

This parameter is visible only if the function "Switching" is set.

This parameter defines the brightness value that is sent at the end of a detection.

This parameter is only visible when the "Brightness value transmitter" function is set.

This parameter defines the scene number that is sent at the end of a recording.

This parameter is visible only if the function "Scene extension" is set.

This parameter determines whether the sensor should react to movements regardless of the ambient brightness or only if the brightness falls below a limit value.

This parameter determines the brightness threshold below which motion detection triggers a switching operation.

This parameter is only visible when the "Brightness-dependent" function is set.

This parameter is a hysteresis, i.e. a value that must be added to the switch-on brightness to arrive at the value of the switch-off brightness. If this value is exceeded, the "Run-on time after switch-off brightness" is started before the switch-off command is sent even if movement is detected.

This parameter is only visible when the "Brightness-dependent" function is set.

If the switch-off threshold is exceeded, the switch-off command is not issued immediately, but the run-on time set in this parameter is started. The switch-off command is only sent after the time has elapsed.

This parameter is only visible when the "Brightness-dependent" function is set.

This parameter defines when the measured brightness value is sent.

If the brightness of the surroundings changes by the value set here, the brightness value is sent.

This parameter is only visible if "Send brightness value" is set to "on change" or "on change and cyclically".

Cyclical sending is active. This parameter specifies the time interval at which the brightness values are sent.

This parameter is only visible if "Send brightness value" is set to "cyclically" or "on change and cyclically".

At this point, the disabling function of the sensor channel can be activated.

If this checkbox is activated, the ETS shows further communication object and parameters.

When the disabling function is activated, the function configured here is triggered.

Only applies to the "Switching" function of the sensor channel

When the disabling function is activated, the function configured here is triggered.

Only applies to the "Brightness value transmitter" function of the sensor channel

When the disabling function is activated, the function configured here is triggered.

Only applies to the "scene extension unit" function of the sensor channel

When disabling is cancelled, the function configured here is triggered.

This parameter defines the value of the disabling object at which the disabling function is active.